Forum

Jennifer Häfner
Moderator
    Has successfully completed the online course Intermediate (200)
    Has successfully completed the online course Advanced (300)
    Has successfully completed the online course Basics (100)
    Has successfully completed the online course Advanced (310)
    Has successfully completed the online course Advanced (320)
    Has successfully completed the Intermediate Certification
    Has successfully completed the Advanced Certification
2 years, 9 months ago #36618
Up
0
Down
::

Check out these two videos from our Intermediate Course where we use the data source to bind data to a list/table:

https://community.simplifier.io/202-2/

https://community.simplifier.io/205-1/

So as Vitali already said, you have to first build the table with a ColumnListItem and the columns that you need, then use the data source property of the ColumnListItem and specify your Connector Call there. Then, drag and drop the data source property from the UI Designer into a story in the Process Designer to define when the Connector Call should be executed (this procedure is also shown in the videos).